17. TROUBLESHOOTING
PROBLEM
Battery connectors do not
spark when touched together.
The charger will not turn on
when properly connected.
I cannot select a language on
the display.
Green LED is lit and the
display shows ANALYZING
BATTERY.
Green LED is flashing and
the display shows CHARGE
ABORTED-BAD BATTERY.
The display shows
CONNECT CLAMPS.
18. SPECIFICATIONS
Input .................................................................................................. 230V AC~50Hz, 3.2A
Output ............................................................................................................... 24V
Ingress Protection rating ..............................................................................................IP20
19. REPLACEMENT PARTS
Battery clamps (quick-connect)..................................................................... 3899003431Z
Ring connectors (quick-connect) ................................................................. 3899003531Z
POSSIBLE CAUSE
The charger is equipped with an
auto-start feature. It will not supply
current to the battery connectors
until a battery is properly connected.
The connectors will not spark if
touched together.
AC outlet is dead.
Poor electrical connection.
Press the button for 5 seconds to
select a language:
(EN→ DE→ FR→ NL→ ES→ IT).
The charger needs to check the
condition of the battery.
The battery is too large for the
charger.
The battery voltage is still below
20V after 2 hours of charging.
The clamps are not making a good
connection.
The fuse is bad.
•
13
No problem; this is a normal
condition.
Check for open fuse or circuit
breaker supplying AC outlet.
Check power cord and extension
cord for loose fitting plug.
No problem; this is normal.
The green LED will be lit when the
charger is checking the condition of
the battery. This is normal.
You need a charger with a higher
amp rate.
Have the battery checked.
Check for poor connection at
battery and frame.
Replace the in-line fuse for the ring
connector.
•
REASON/SOLUTION
10A