Rear Panel - Kenwood TS-890S Instruction Manual

Rear Panel

.
Connectors and Jacks on the Rear Panel
No. Name
<ANT 1> Connector
<ANT 2> Connector
.
<REF IN (10MHz)> Connector
.
<DC13.8V> Connector
.
<USB-A> Connector
.
<COM> Connector
.
<AT> Connector
.
<EXT.SP> Jack
.
<LAN> Connector
.
<DISPLAY> Connector
.
<USB-B> Connector
.
<KEY> Jack
.
<METER> Terminal
.
<REMOTE> Connector
.
<ACC 2> Connector
.
<KEYPAD> Jack
.
<DRV> Connector
.
<ANT OUT> Connector
.
<RX IN> Connector
.
<RX OUT> Connector
.
<GND> Terminal
.
Description
M-type coaxial connector for connecting the antenna.
For input of 10 MHz signals when using an external reference
frequency.
For connecting a regulated DC power supply.
Connector for connecting a USB flash drive or USB keyboard.
RS-232C connector for connecting a PC or external device.
Connector for controlling an external amplifier tuner.
For connecting an external speaker.
Connector for connecting a PC or LAN when running with the KNS
(KENWOOD NETWORK COMMAND SYSTEM) or for automatic
correction of the clock time.
DVI-I connector for connecting an external monitor. Both analog
and digital signals can be output.
Connector for connecting a PC. It is used to control this transceiver
using the ARCP-890 as well as to input and output signals for
transmission and reception via the digital communication
application of a PC. It can be switched between transmission and
reception by changing the menu setting and keying.
For connecting an electronic key (straight key, bug key, external
electronic key, etc.) when running in the CW mode. This can be
configured to a jack for paddle connection in the menu.
For connecting a commercially available meter.
For connecting a linear amplifier. (Use the supplied 7-pin DIN plug
for the connection.)
For connecting an external device such as an external terminal.
(Use the supplied 13-pin DIN plug for the connection.)
For connecting a self-made PF keypad.
For connecting a transverter or linear amplifier.
For connecting devices such as an external receiver.
For connecting an RX antenna, external bandpass filter, transverter
and the like.
For connecting an external bandpass filter and the like.
For connecting a ground wire.
NAMES AND FUNCTIONS OF PARTS 2
Remarks
• Input impedance: 50 Ω
• Input: 0 dBm ±10 dB
• Output impedance: 4.7 Ω
• Allowable open-end voltage
output: 0 to 5 V
• Output impedance: 50 Ω
• Output: Approx. 1 mW (0 dBm)
2-7