Part Removal And Replacement; Threader Plate - Janome DE 5024 Servicing Manual

PART REMOVAL AND REPLACEMENT

THREADER PLATE

When the hook of the threader plate (F) is damaged, change or adjust the part as follows.
TO CHANGE THE THREADER PLATE:
1. Raise the needle to its highest position, and lower the threader knob (D) to its lowest
position.
2. Remove the screw (E) to remove the threader plate (*** A ***).
TO CHANGE THE NEEDLE THREADER:
1. If the hook (H) of the threader plate (F) touches the left or right side, loosen the screw (E)
and adjust the hook position (*** B ***).
2. If the hook (H) of the threader plate (F) touches the top or bottom side of the needle hole,
loosen the screw (G) and adjust the hook position (*** C ***).
2 6