Quadra-Fire VOYAGEUR-MBK Installation Manual page 26

VOYAGEUR Insert ACC
12. Insert the control plate assembly back into the
appliance as shown. Tilt the assembly forward and
then lift up and rotate the bottom towards the front of
the appliance at the same time ensure that the snap
disc holder is properly seated. Secure plate to the
appliance.
Figure 26.1
13. Push in the blower and hold down bracket into
appliance matching up the tab on the bracket and
placement slot on the appliance. Secure bracket and
reconnect blower wires (no polarity to worry about)
routing wires through the retainer clip.
Route Wires through Retainer Clip
Replace Screws in Hold Down Bracket
Figure 26.2
26 7063-513I August 13, 2018