Assembly; Assembling Leg Stand; Assembling Storage Brackets - Ryobi BTS15 Operator's Manual

Assembly is best done in the area where the saw will be
used. When you remove the table saw base, loose parts, and
hardware from the packing materials, check all items with the
loose parts list and drawing. If you are unsure about the
description of any part, refer to the drawing. If any parts are
missing, delay assembling until you have obtained the
missing part(s).

ASSEMBLING LEG STAND

See Figures 7 and 8.
Take the following hardware from the leg stand hardware
bag:
24 carriage bolts (5/16-18 x 5/8 in.)
1 leveling foot
6 flat washers (5/16 in.)
28 hex nuts (5/16-18)
3 feet
Note: Remaining hardware from this bag is used for
mounting leg stand on the table saw base and mounting
the storage bracket to the upper brace.
Take 4 legs and 8 braces from loose parts.
Place an upper side brace inside leg with the leg's wide
end up.
Note: Upper braces have large holes in each end; these
holes should be on top when leg stand is completely
assembled as shown in figure 8.
Align the holes on the brace and the legs. Insert two
carriage bolts and hand tighten using hex nuts. These are
the front and back sets.
For the side sets, install an upper brace on two legs. Add
hardware and finger tighten. Repeat for the other upper
brace.
Use the same steps to install the lower braces. Tighten all
hex nuts with a wrench.
Place a hex nut and flat washer on the leveling foot. Install
the leveling foot from the bottom of the leg with the bolts
pointing up. Cap with the remaining flat washer and hex
nut but do not tighten.
Place one foot on the bottom of each of the remaining
three legs.
Move the leg set to desired location. Adjust the leveling
foot with a wrench, then tighten the top hex nut.

ASSEMBLING STORAGE BRACKETS

Take storage brackets from loose parts.
Take the following hardware from the leg stand hardware
bag:
2 screws (1/4-20 x 1/2 in. Pan Hd.)
2 hex nuts (1/4-20)
2 washers (1/4 in.)
Secure storage brackets to upper braces of leg stand as
shown in figure 7.

ASSEMBLY

Page 15
Fig. 7
Fig. 8