Assembly; Assembling Leg Stand - Ryobi BS1001SV Operator's Manual

UNPACKING
This product requires assembly.
n Carefully remove the tool and any accessories from the
box. Place it on a level work surface.
NOTE: This tool is heavy. To avoid back injury, lift with
your legs, not your back, and get help when needed.
n Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
n Do not discard the packing material until you have
carefully inspected the tool, identified all loose parts,
and satisfactorily operated the tool.
n If any parts are damaged or missing, please call 1-800-
525-2579 for assistance.
WARNING:
If any parts are missing do not operate this tool until the
missing parts are replaced. Failure to do so could result
in possible serious personal injury.
WARNING:
Do not attempt to modify this tool or create accesso-
ries not recommended for use with this tool. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
injury.
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental
starting and possible serious personal injury.
Assembly is best done in the area where the saw will be
used. When you remove the table saw base, loose parts,
and hardware from the packing materials, check all items
with the loose parts list and drawing. If you are unsure about
the description of any part, refer to the drawing. If any parts
are missing, delay assembling until you have obtained the
missing part(s).

ASSEMBLING LEG STAND

See Figures 6 and 7.
n Locate the following hardware:
16 carriage bolts
4 carriage bolts, small
16 hex nuts
4 hex nuts, small
4 feet
n Take 4 legs and 8 braces from loose parts.
n Place top braces inside legs.

ASSEMBLY

n Align the holes on the brace and the legs. Insert two
carriage bolts and hand tighten using hex nuts. These
are the front and back sets.
n For the side sets, install a side brace on two legs. Add
hardware and finger tighten. Repeat for the other side
brace. See Figure 7.
HEX NUT
LEG BRACE
(LONG)
Page 13
TOP BRACE
CARRIAGE
BOLT
TOP BRACE
Fig. 6
CARRIAGE
BOLT
HEX NUT
Fig. 7