Table of Contents
Advertisement
UNO-LRC1 Remote Control Operation
Turning the unit on
The tuner is power managed by the CAV6.6 or
other RNET-enabled controller. If the tuner is in
standby mode, any button press of the UNO-
LRC1 will bring the tuner out of standby mode
when used with the UNO keypad.
Selecting the desired tuner
To select a tuner, push
number preassigned to Tuner 1 (XM1) or Tuner 2
(XM2), or use the UNO numeric source inputs at the
bottom of the UNO-LRC1.
Selecting an XM Mode
Push
,
,
between XM operating modes.
Exiting an XM Mode
Press
or
to exit XM operating mode menu.
Signal Strength mode
Press and hold
and release. The display shows
the signal strength rating. To exit press
Selecting the desired channel
Use the Channel
and
for manual tuning. To move quickly through the
channels, press and hold the button for more than
1.5 seconds. To directly select a channel, enter the
three- or four-digit channel number.
UNO-LRC1 REMOTE CONTROL WITH CAV6.6/CAM6.6
and choose the source
,or
to toggle
.
or
and
ST2-XM2 OPERATION
Selecting a Bank
To select a bank, press and hold
or
for bank down.
Recalling a Memory Preset
Press
and
or
through a loop of all the memory presets for the cur-
rently selected bank. Only configured presets will be
displayed.
Mute
Press the
button to mute/unmute the tuner
audio output.
for bank up
and
to scroll
23
Advertisement
Table of Contents
