Fujitsu AGU9RLF Design & Technical Manual page 30

4) Room temperature control for heating
Depending on the installed environment, correction of the room temperature sensor may be
required.
Select the appropriate control setting according to the installed environment.
Setting description

Standard
Lower control
Slightly higher control
Higher control
5) Auto restart
Enable or disable automatic restart after a power interruption.
Setting description

Enable
Disable
* Auto restart is an emergency function such as for power outage etc.
Do not attempt to use this function in normal operation.
Be sure to operate the unit by remote controller or external input device.
6) Room temperature sensor switching
(Only for wired remote controller)
When using the Wired remote controller temperature sensor, change the setting to "Both" (01).
Setting description

Indoor unit
Both
00: Sensor on the indoor unit is active.
01: Sensors on both indoor unit and wired remote controller are active.
7) Remote controller custom code
(Only for wireless remote controller)
The indoor unit custom code can be changed.
Select the appropriate custom code.
Setting description

A
B
C
D
(  ... Factory setting)
Function number
Setting value
31
(  ... Factory setting)
Function number
Setting value
40
(  ... Factory setting)
Function number
Setting value
42
(  ... Factory setting)
Function number
Setting value
44
- (01 - 27) -
00
01
02
03
00
01
00
01
00
01
02
03