Accessories - Baldor MN605 Installation And Operating Manual

Accessories

The following list shows some accessories available through Baldor's Mod Express or available on custom
manufactured motors. Contact your Baldor supplier for information on each additional accessory or those listed
below.
Bearing RTD
RTD (Resistance Temperature Detector) devices are used to measure or monitor the temperature of the motor
bearing during operation.
Bearing Thermocouples
Used to measure or monitor bearing temperatures.
Bearing Thermostat
Temperature device that activates when bearing temperatures are excessive. Used with an external circuit to warn
of excessive bearing temperature or to shut down a motor.
Blowers with Filters
Available to increase the constant torque speed range of DPFG motors. This increases the continuous operating
torque range at low speeds.
Brush Wear Indicator
Provides a warning when the brushes have worn down to the level where they need to be replaced (before
damage to the commutator).
Condensation Drains & Breathers
Stainless steel drains and separate breathers are available.
Conduit Boxes
Optional conduit boxes are available in various sizes to accommodate accessory devices.
Cord & Plug Assembly
Adds a line cord and plug for portable applications.
Drip Covers
Designed for use when motor is mounted in a vertical position. Contact your Baldor distributor to
confirm that the motor is designed for vertical mounting.
Fan Cover & Lint Screen
To prevent build-up of debris on the cooling fan.
Nameplate
Additional stainless steel nameplates are available.
Roller Bearings
Recommended for belt drive applications with a speed of 1800 RPM or less.
Rotation Arrow Labels
Rotation arrows are supplied on motors designed to operate in one direction only. Additional rotation arrows are
available.
Slide Bases
Allows easy belt adjustment while maintaining correct pulley and belt alignment.
Space Heater
Added to prevent condensation of moisture within the motor enclosure during periods of shut down or storage.
Stainless Hardware
Stainless steel hardware is available. Standard hardware is corrosion resistant zinc plated steel.
Tachometers
DC, AC and digital outputs are available. These can be mounted to our motors or shipped separately.
Tachs help the SCR control achieve more precise speed regulation than by armature feedback alone.
Transparent Brush Inspection
For easy brush inspection and commutation monitoring without disassembly of the motor.
Winding RTD
RTD (Resistance Temperature Detector) devices are used to measure or monitor the temperature of the motor
winding during operation.
Winding Thermocouples
Used to measure or monitor winding temperatures.
Winding Thermostat
Temperature device that activates when winding temperatures are excessive. Used with an external circuit to
warn of excessive winding temperature or to shut down a motor.
3-8 MN605