Table of Contents
Advertisement
8.
IMPORTANT!
Bounce pole top (1) and middle section (2)
together as shown until they no longer move toward taped
reference mark.
NOTE: Pole sections should have a 4-1/2" (11.4 cm)
minimum overlap.
9.
IMPORTANT!
Add bottom pole section (3) to assembly.
Bounce pole sections together 3 times, rotate 90° and repeat
rotation bounce procedure. Continue this step until pole
sections are completely tight.
10.
Drill a hole in the backside of each of the two pole
sections joint areas, 1" (2.54 cm) above bottom of
poles and install screws (10) as shown. NOTE: Drill
bit (9) provided.
11.
Insert pole cap (11) onto end of bottom pole (3). Mix
concrete (approximately 100 lbs. (45.4 kg)) and fill
pole 1"-2" (2.54-5.0 cm) below bottom elevator hole on
top pole section (1) as shown.
IMPORTANT!
WAIT MINIMUM OF
24 HOURS BEFORE
GOING ON TO NEXT
STEP. CONCRETE
MUST CURE.
IMPORTANT!
FAILURE TO FILL YOUR POLE
COMPLETELY WITH CONCRETE AS
DESCRIBED IN THESE
INSTRUCTIONS WILL VOID ALL
WARRANTIES WRITTEN OR
IMPLIED.
NOTE: Pole sections
should have a 4-1/2"
(11.4 cm) minimum
overlap.
1
FILL LINE
7
1
2
WOOD SCRAP
WARNING
TWO PERSON MINIMUM
REQUIRED FOR THIS
10
NOT FOLLOWING
RECOMMENDATION MAY
RESULT IN BODILY INJURY.
2
3
PROCEDURE.
10
9
11
05/03
P/N 211376A
Advertisement
Table of Contents
