www.sylvania.com
D6 Area Light LED Retrofit Kit
INSTALLATION GUIDE
Above image of 55W model.
TO PREVENT PERSONAL INJURY OR PRODUCT DAMAGE ONLY LICENSED ELECTRICIANS SHOULD PROVIDE ALL INSTALLATION
SERVICES.
FAILURE TO INSTALL THIS PRODUCT IN ACCORDANCE WITH THE NATIONAL ELECTRIC CODE (NEC), OR THE CANADIAN
ELECTRICAL CODE (CSA 22.1), ALL APPLICABLE FEDERAL, STATE AND LOCAL ELECTRIC CODES AS WELL AS THE SPECIFIC
UNDERWRITERS LABORATORIES (UL) SAFETY STANDARDS FOR THE INSTALLATION, LOCATION AND APPLICATION MAY CAUSE
UNSAFE SITUATIONS LEADING TO SERIOUS PERSONAL INJURY, DEATH, PROPERTY DAMAGE AND/OR PRODUCT MALFUNCTION.
TO AVOID ELECTRIC SHOCK OR COMPONENT DAMAGE DISCONNECT POWER BEFORE ATTEMPTING INSTALLATION OR
SERVICING.
INSTALLATION MUST BE STRUCTURALLY SOUND AS TO PREVENT DAMAGE OR PERSONAL INJURY DUE TO FIXTURE COLLAPSE.
USE CAUTION WHEN HANDLING THIS PRODUCT DURING OR AFTER OPERATION AS IT MAY BECOME HOT AND CAUSE BURNS.
DISCONNECT PRODUCT AND ALLOW COOLING PRIOR TO SERVICING.
ANY ALTERATION OR MODIFICATION OF THIS PRODUCT IS EXPRESSLY FORBIDDEN AS IT MAY CAUSE SERIOUS PERSONAL
INJURY, DEATH, PROPERTY DAMAGE AND/OR PRODUCT MALFUNCTION.
TO PREVENT PRODUCT MALFUNCTION AND / OR ELECTRICAL SHOCK THIS PRODUCT MUST BE PROPERLY GROUNDED.
DO NOT MAKE OR ALTER ANY OPEN HOLES IN AN ENCLOSURE OF WIRING OR ELECTRICAL COMPONENTS DURING KIT
INSTALLATION.
TO PREVENT WIRING DAMAGE OR ABRASION, DO NOT EXPOSE WIRING TO EDGES OF SHEET METAL OR OTHER SHARP
OBJECTS.
TO PREVENT RISK OF FIRE OR ELECTRIC SHOCK. INSTALL THIS KIT ONLY IN THE LUMINARIES THAT HAVE THE CONSTRUCTION
FEATURES AND DIMENSIONS SHOWN IN THE PHOTOGRAPHS AND/OR DRAWINGS.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Even though this product may continue to light after the lens is cracked or broken, or after the specified lifetime has passed, it must be
replaced in order to maintain appropriate light levels.
Failure of fixture to provide sufficient weather protection voids warranty.
To prevent early product failure, this product should be installed in operating environments with maximum mean ambient operating
temperature for LED Retrofit Module: 104°F (40C); maximum ambient operating temperature cannot exceed 140°F (60°C).
Installation requirements may vary depending on the luminaire retrofitted.
Incorrect electrical polarity may damage the module.
If installed in fixture other than acorn or shoebox, contact UL customer service department at (877) 854-3577 to certify retrofitted fixture.
RETRO0018 07/10
!
PLEASE READ ALL INSTRUCTIONS BEFORE ATTEMPTING INSTALLATION
The D6 Area Light LED Retrofit Kit from SYLVANIA is an
alternative to high-intensity discharge (HID) lamps up to 175W
at pole heights up to 30 feet. The directional light distribution of
high power LEDs allows the delivery of light only where
needed, reducing wasted light and minimizing light trespass
and upward emissions. The D6 is an environmentally friendly
lighting solution as it contains no mercury or lead. It is an
excellent solution for communities that wish to convert their
existing lighting systems as it offers substantial energy and
maintenance cost savings as well as minimizes waste in
landfills.
WARNING
NOTICE