Configure For A Building Automation System - Bradford White Brute Installation And Operating Instructions Manual

Brute
HIGH EFFICIENCY COMMERCIAL BOILERS AND VOLUME WATER HEATERS
8.8 Configure for a
Building Automation System
Brute boilers can be controlled and monitored through the
included Modbus ports. If communication protocols are
desired, Bradford White offers the Gateway Control to
allow BACnet, LON, and other communications protocols.
The Modbus Connections must be completed as shown in
Figure 35 on page 38, and Figure 36 on page 40.
And you must set up your CH Configuration for SetPoint
and Modulation as shown on Menu 19 on page 51
For additional information on setting up Modbus and other
communication protocols, contact the factory.
Menu 21. Home Screen
Starting at the Home Screen, tap onto the Display Setup
button on the bottom right of the lead boilers screen.
Menu 22. Setup Menu
From the Setup menu, tap the Display Setup button.
Menu 23. Display Setup -COM2
Select the COM2 tab and make sure that the COM2 port
is enabled.
Menu 24. Display Setup -Gateway
Select the Gateway tab and make sure that the
Gateway on COM2 port is enabled. Then return to the
Homescreen.
Page 63