Burst Of Steam/Vertical Steam; Dry Ironing; Spray Setting - Rowenta P2 Professional Instructions For Use Manual

SPRAY SETTING

BURST OF STEAM
VERTICAL STEAM
The iron can also be used vertically. This is
especially useful for getting creases out of
hanging clothes, curtains, tapestries, etc.
POINT TO NOTE
If the iron has not been used for a long time (e.g. several weeks) the
steam channels should be cleaned and any deposits removed from the
iron. To do this, hold the iron horizontally before you start to use it
and allow it to produce steam for about 1 minute. Also activate the
burst of steam button several times.

DRY IRONING

max
m in
Self
Cle an
Ensure there is water in the tank.
Moistening the fabric with the spray will
make wrinkle removal easier.
Press the spray button down slowly for a
jet or quickly and strongly for a mist.
Do not spray silk, etc.
To remove stubborn wrinkles or press in
a sharp crease, use the burst of steam
button.
Press the button firmly, a strong burst of
steam penetrates deep into the fabric.
Leave an interval of at least four seconds
between pressing the burst of steam
button.
With water in the tank, the burst of
steam button can be used as soon as the
steam ironing temperature has been
reached ( ).
Warning:
Never iron clothes while they are
being worn.
Slide the variable steam control fully to
the left. We recommend dry ironing with
an empty tank to be sure there are no
drips, but it can also be performed with
water in the tank.
7