Advertisement
The safety rules define three volumes in a bathroom (see diagram 5). this unit must only be ins-
talled in volume 3 of the room so that the selector button (A) cannot be touched by anyone using
the bath or the shower.
2 - VOLTAGE
Before using the appliance for the first time, ensure that your mains voltage corresponds to the
voltage indicated on the appliance.
Your appliance can be used with a power plug without an earth connection. It is a class II
appliance (dual electrical insulation
3 - SAFETY
Heat safety
In the event of abnormal overheating, a safety device automatically cuts out the appliance. Before
re-using your appliance, you must turn it off by turning the button (A) to b setting
(mod. HA 435 - HA 475) then unplug the power plug (mod. HA 425 - HA 435 - HA 475) and wait
for the temperature of the appliance to return to normal (approximately 15 min).
Protect Signal: safety beep (mod. HA 475 only)
Your appliance is fitted with an exclusive audible safety system.
If your appliance is not working properly, creating a potential risk (appliance covered, tipping over,
grill clogged up, partially or completely blocked), a safety device automatically cuts it out.
An exclusive electronic system starts up and issues a beep, to warn you that the appliance is
overheating.
To stop the beep and restart your appliance, you must:
– turn the button (A) to the b setting
– unplug the power plug,
– eliminate the cause of overheating,
– then wait for the temperature to return to normal (approximately 15 min).
If your appliance starts beeping again, please consult the paragraph entitled "IN THE EVENT OF
PROBLEMS", at the end of this instruction booklet.
4 - OPERATION
Starting up the appliance and choosing the operating mode:
Frost-free setting
This setting enables you to automatically maintain the temperature above 0°C in a normally insu-
lated room, whose volume corresponds to the power of your appliance.
To do this, plug in your appliance and turn button (A) so that the "
indicator (B).
Heating light.
This light (D) only comes on when your appliance is in heating mode.
Mod. HA 425
Your appliance operates at 2400 W as soon as it is plugged into the mains supply, if the thermo-
stat is tripped.
Adjust the temperature setting, according to your own comfort, by turning button (A) (fig. 1):
Setting 9: opposite mark (B) = warmer
Setting 1: opposite mark (B) = cooler.
Mod. HA 435 and HA 475
Your appliance has 3 operating modes. Simply position the symbol corresponding to the chosen
mode opposite mark (B) on the housing (fig. 2).
).
" symbol is placed opposite
Advertisement
