Hummer H3 2006 Getting To Know Your page 5

2. Press and release the reset stem
until OIL LIFE is displayed.
3. Once the alternating OIL LIFE and
RESET messages appear, press and
hold the reset stem until several
beeps sound.
4. Turn the key to Off.
Note: The Oil Life System must be
reset after each oil change to help
ensure the proper maintenance of your
vehicle. The Oil Life System does not
replace the need to follow the mainte-
nance schedule in the Owner Manual.
For service information, see Section 5
of your Owner Manual.
Program the Automatic Door Locks
To program the door locks to operate in
one of three modes:
1. With the engine Off, turn the key to
Lock. Do not remove the key.
2. Press and hold the power door lock
button for approximately three sec-
onds until the DIC displays the cur-
rent door lock mode.
3. To view each next available mode,
press, hold for approximately two
seconds, and then release the reset
stem.
4. Once the preferred mode is dis-
played, briefly press the reset stem to
set your choice. The DIC display will
then clear.
Program the Remote Keyless Entry
Feedback
To program the Remote Keyless Entry
(RKE) feedback to one of four modes:
1. With the engine Off, turn the key to
Lock. Do not remove the key.
2. Press and hold both the lock and
unlock buttons on the RKE transmit-
ter until the DIC displays the current
RKE feedback mode.
3. To view each next available mode,
press, hold for approximately two
seconds, and then release the reset
stem.
4. Once the preferred mode is dis-
played, briefly press the reset stem to
set your choice. The DIC display will
then clear.
Selecting a Language
To select the DIC language:
1. With the engine Off, turn the key
to On.
2. Close all doors.
3. Press and release the reset stem
until LANGUAGE is displayed.
4. To view each available language,
press and hold the reset stem for
2 seconds.
5. Once the desired language is dis-
played, briefly press the reset stem
to set your choice.
Warnings and Messages
Warnings and messages are displayed
on the DIC to notify the driver that the
status of the vehicle has changed and
that some action may be needed by the
driver.
Each message must be acknowledged.
To acknowledge and clear a message
from the DIC, press and release the
reset stem.
If your vehicle is equipped with OnStar
and your Malfunction Indicator lamp
(Check Engine light) illuminates, or any
other warning message appears, you
can press the blue OnStar button and
speak to an OnStar advisor. In many
5