Accounts; Ipv4 Filter; Encryption - Bosch AUTODOME IP 4000i User Manual

AUTODOME IP 4000i/AUTODOME IP 5000i/
AUTODOME IP 5000i IR
Enable
Check the box to enable best face posting.
File format
Select the type of image to be sent.
Target
Select the target account for best face posting.
Timeout
Fill in the timeout in seconds. Leave at 0 for no timeout.
Maximum image width [px]
Fill in the maximum image width in pixels. Leave at 0 for automatic width selection.
10.8

Accounts

Four separate accounts can be defined for posting and recording export.
Type
Select either FTP or Dropbox for the account type.
Before using a Dropbox account ensure that the time settings of the device have been
correctly synchronized.
Account name
Enter an account name to be shown as the target name.
IP address
Enter the IP address of the server on which you wish to save the JPEG images.
Login
Enter the login ID for the server.
Password
Enter the password that gives you access to the server. To verify the password, click the
Check button to the right.
Path
Enter the exact path on which you wish to post the images on the server. To browse for the
correct path, click the Browse button to the right.
Maximum bit rate
Enter the maximum bit rate for the JPEG images (in kbps).

Encryption

Tick the box to use a secure FTP over TLS connection.
10.9

IPv4 Filter

Use this setting to configure a filter that allows or blocks network traffic that matches a
specified address or protocol.
IP Address 1 / 2
Enter the IPv4 address that you want to allow or block
Mask 1 / 2
Enter the subnet mask for the appropriate IPv4 address.
10.10 Encryption
If an encryption license is installed, this submenu gives access to the encryption parameters.
Bosch Security Systems User Manual
Network | en 63
2018.05 | 1.1 |