DigiTech RP1000 Quick Start Manual page 2

3
USING PRESET & PEDALBOARD MODES
A. To toggle between Preset and Pedalboard modes, press the button.
PEDALBOARD
B. When the PEDALBOARD button is lit, the RP1000 is in Pedalboard mode and pressing the
footswitches will turn individual effects (e.g., compressor, distortion, etc.) on or off, just
6-10
like when using stompboxes on a pedalboard.
C. When the Toggle between Preset
PEDALBOARD and Pedalboard modes
button is not lit,
the RP1000 is
in Preset mode
and the 6-10
footswitches will
select presets.
Select presets (Preset mode) or
effects on/off (Pedalboard mode)
4
SELECTING, EDITING, & STORING PRESETS
A. To select a preset, press the UP or DOWN footswitch to select a different bank then press
one of the 1-5 footswitches (Pedalboard mode) or 1-10 footswitches (Preset mode).
B. Turn the TONE LIBRARY and EFFECTS LIBRARY knobs to select other tones/effect chains.
C. Press the UP/DOWN EDIT buttons to select a specific effect for editing (the selected effect
LED will light). Press the TONE LIBRARY
knob to turn the effect on/off. Look Press to Selected
edit effect effect select a Bank
at the parameter matrix and use
the KNOBS to edit the effect.
D. To exit Edit mode, press one of the
1-5 footswitches.
E. To store the preset, press the
STORE button.
F. Use the TONE LIBRARY and
EFFECTS LIBRARY knobs to edit
the preset name.
G. Press the STORE button a 2nd time.
H. Optional: Press the UP or DOWN
footswitch to relocate the preset.
I. Press the STORE button a 3rd time
to store the preset.
Press to select a Preset
DigiTech
• 801.566.8800 • digitech.com
5
USING THE LOOPER
A. To enable the Looper, press the LOOPER button. The LOOPER LED will light.
NOTE: When the Looper is enabled, the UP / DOWN footwitches will be used for Looper
control, so they cannot be used for preset bank up/down selection.
B. Press the DOWN footswitch to arm the looper for recording. The RECORD LED will begin
flashing.
Press to C. Begin playing. When done, press the DOWN footswitch again on the same downbeat you
started on.
D. If you want to play over the top of the loop with different guitar tones/effects, select a
different preset or edit the effects.
E. While the loop is playing, press the DOWN footswitch to record an overdub. The OVERDUB
LED will light. When done, press the DOWN
footswitch again to stop overdub recording.
Repeat to record additional overdubs.
F. Press the UP footswitch to stop the Looper and
DOWN footswitch to play the Looper.
G. To clear the loop, stop playback then press and
hold the UP footswitch for 2 seconds. The display
will briefly read "LOOPCLRD". Repeat steps B- E to
record a new loop.
H. To exit the Looper, press the LOOPER button.
© 2016 Harman.
DigiTech is a registered trademark of Harman.
All rights reserved.
QUICK START GUIDE
Enable/Disable Looper
Control Looper
PN: 5059525-A