Power Management Mode - Canon WUX7500 User Manual

Menu Description
Power supply settings
> [System settings] >
Specify how power is managed at startup, in standby, and when no signal is
supplied.
Standby power setting
Specify network function operating status in standby mode.
Option
All network functions are available when network functions are
Normal
enabled, including the web screen and PJLink.
All functions are disabled except for some wired LAN functions (such
Low-power
as operations over a network).
• [Standby power setting] is set to [Normal] and cannot be changed when scheduling
is enabled (P167).
• [Standby power setting] is set to [Normal] and cannot be changed when wireless
LAN is enabled (P175).
• [Standby power setting] is set to [Normal] and cannot be changed when IPsec
function is enabled (P205).

Power management mode

Specify to turn the light source off or enter standby if there is no input signal. This feature
automatically turns off the light source or power after a certain period if the remote control or
projector is not operated.
Option
Disabled Disable power management mode.
Light source off Only turns the light source off.
Standby Turns the projector off and puts it in standby.
• Projection resumes when the same input signal is restored, when the remote control
or projector is operated, or when user commands are sent to turn the projector on.
• After the projector enters standby, restoring projection requires the same steps as
when turning the projector on normally.
• When [Disabled] is selected, [Direct power on] is not available.
[Power supply settings]
162
Function
Function