Chapter 2 Setup Procedure For Qlogic Converged Network Adapter Cards; Workflow - Fujitsu ETERNUS DX Configuration Manual
Server connection, fcoe for vmware esx driver settings for non-fujitsu converged network adapter cards
Hide thumbs
Also See for ETERNUS DX:
- Configuration manual (85 pages) ,
- User manual (42 pages) ,
- Configuration manual (44 pages)
Table of Contents
Advertisement
Chapter 2
Setup Procedure for QLogic Converged Network
Adapter Cards
This chapter describes how to set up the VMware ESX server and driver when connecting the ETERNUS DX
storage systems to the server via QLogic Converged Network Adapter cards.
2.1
Workflow
Workflow
Setting Up the Converged Network Adapter Cards
Install the Converged Network Adapter cards, acquire their physical addresses and WWN information.
"2.2.1 Setting Up the Converged Network Adapter Cards" (page 23)
•
Setting Up SAN Boot
Set up the SAN Boot configuration (if SAN Boot is to be used).
"2.2.2 Setting Up SAN Boot" (page 26)
•
Installing VMware ESX
Install the VMware ESX software.
"2.2.4 Installing VMware ESX" (page 28)
•
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (FCoE) for VMware
21
Copyright 2015 FUJITSU LIMITED
®
ESX
P3AM-4772-11ENZ0
Advertisement
Table of Contents
