Technical Support - NETGEAR JGSM7224 Installation Manual

JGSM7224 IG Aug2012.fm Page 2 Monday, August 27, 2012 11:22 AM
c. At the command prompt User: , log in to the switch using the user name
admin , then press Enter. Press Enter again, no password is needed for
initial configuration. The (JGSM7224)> prompt displays.
d. The following procedure uses CLI commands to set a static IP address and
subnet mask. Refer to the JGSM7224 CLI Reference Manual for command
descriptions. The IP address used is only an example. End each command
line with Enter.
(JGSM7224) > enable
(JGSM7224) # configure terminal
(JGSM7224) (config)# interface vlanmgmt
(JGSM7224) (config-if)# no ip address
(JGSM7224) (config-if)# ip address 10.10.10.1 255.255.255.0
(JGSM7224) (config-if)# exit
(JGSM7224) (config)# exit
(JGSM7224) # save
Building configuration ...
[OK]
(JGSM7224) #
3. You can now use this IP address to log in to the switch through its web
management interface. See Web Login to the Switch.
Computer in DHCP Client Mode with DHCP Server
By default, the switch is configured as a DHCP client to obtain its IP address from a
DHCP server in the connected network. You must access the switch from the serial
console port.
1. Make sure that the switch is connected to a DHCP server.
2. Determine the switch IP address the DHCP server assigns.
a. Perform steps 1 through 2.c of the procedure Computer with static IP
address.
b. Type the show management vlan command and press Enter. A screen
displays that shows the active switch IP address.
c. Use this IP address to log in to the switch through its web management
interface (see Web Login to the Switch).
Web Login to the Switch
Use the appropriate IP address for your configuration to manage your switch
through its web interface.
1. Type http://<ipaddress> into the URL window of your browser. A screen
similar to the following, displays.
2. Type admin for the user name and leave the password field blank.
3. Click LOGIN. The Management screen displays. You can now use the switch
menu to configure your switch.
Statement of Conditions: In the interest of improving internal design, operational function, and/or reliability,
NETGEAR reserves the right to make changes to the products described in this document without notice.
NETGEAR does not assume any liability that may occur due to the use or application of the product(s) or circuit
September 2012
layout(s) described herein.

Technical Support

After installing your device, locate the serial number on the label of your product and
use it to register your product at https://my.netgear.com.
You must register your product before you can use NETGEAR telephone support.
NETGEAR recommends registering your product through the NETGEAR website.
For product updates and web support, visit http://support.netgear.com.
You can get the reference manual online at http://downloadcenter.netgear.com
through a link in the product's user interface.
This symbol appears in accordance with the European Union Directive 2002/96 on the Waste
Electrical and Electronic Equipment (the WEEE directive). If you dispose of this product in the
European Union, treat and recycle it in accordance with your jurisdiction's laws that implement the
WEEE directive.
NETGEAR, the NETGEAR logo, and Connect with Innovation are trademarks and/or registered trademarks of
NETGEAR, Inc. and/or its subsidiaries in the United States and/or other countries. Information is subject to
change without notice. Other brand and product names are registered trademarks or trademarks of their
respective holders. © NETGEAR, Inc. All rights reserved.
For indoor use only in all EU countries and Switzerland.
or