Advertisement
Users must use the Null-Modem
cable directly connected to the
Cellular Gateway. The Null-Modem
DB9 connector shown in the
Important
picture must be used.
4.1. Logon to Console
Once the terminal is connected to the device, power on the Cellular
Gateway, and the terminal will display "running testing procedures".
Then, the following message asks to log-in user name and password.
The factory default user name and password are shown as follows and
the login screen in Figure 4-3 appears.
Username: admin
Password: admin
Figure 4-3: Cellular Gateway Console Login Screen
The user can now enter commands to manage the Cellular Gateway.
For a detailed description of the commands, please refer to the
following chapters.
1. For security reason, please change and memorize the new
password after this first setup.
2. Only accept command in lowercase letter under console
Note
interface.
4.2. Configuring IP Address
The Cellular Gateway is shipped with default IP address shown below.
9
Advertisement
