Mounting
8.5 Mounting 22.5 mm/17.5 mm devices on a standard mounting rail
8.5
Mounting 22.5 mm/17.5 mm devices on a standard mounting rail
Requirements
● A horizontal 35-mm wide mounting rail in accordance with DIN EN 60715 has been
properly secured at the installation location.
● Please observe the information about the mounting position in the chapter "General
technical data (Page 203)".
Procedure
The figures show 22.5 mm devices. The 17.5 mm devices are mounted correspondingly.
Step
1
Place the back of the device onto the
upper edge of the standard mounting
rail.
2
Press the lower half of the device
against the DIN rail until the device
engages.
142
Instructions
Figure
SIRIUS 3SK1 safety relays
Manual, 06/2018, A5E02526190021A/RS-AD/004