Power-Up; Error Statuses - Siemens SIRIUS 3SK1 Manual

Display and diagnostics

12.2 Power-up

LED Display
(4) SF OFF*
Green
Green flashing
Yellow
Yellow flashing
Red
Red flashing
* LED flashes briefly in configuration mode due to lamp test
12.2 Power-up
Display mode during power-up / parameterization in configuration mode
LED Display
(1) DEVICE Yellow or yellow flashing
Off
(2) OUT Yellow or yellow flashing
Off
(3) IN Yellow or yellow flashing
Flickering yellow
Flickering red
Off
(4) SF Yellow or yellow flashing
Off
12.3

Error statuses

LED Display
(1) DEVICE Red
(4) SF Red
Red flashing
200
Explanation
No group error
Configuration mode DIP (4) position: left
Power-up: hardware test
Short-circuit on the SET/RESET button
Power-up DIP (4) position: right
Configuration mode DIP (4) position: right
Group error (e.g. cross-circuit at input, short-circuit to P, device configuration
changed)
Error message (e.g. short-circuit T1/T2, violation of simultaneity, violation of
two-hand operation timeout, feedback circuit error, START-button pressed too
long), connection of control supply voltage (A1/A2) to an expansion unit that is
connected via a device connector)
Explanation
Monitored start
Autostart
Cross-circuit detection ON
Cross-circuit detection off
1 x two-channel
Configuration mode: Special two-hand operation configuration
Configuration mode: impermissible configuration
2 x single-channel
Startup testing off
Startup testing ON
Explanation
Device error
Group error
Fault message
SIRIUS 3SK1 safety relays
Manual, 06/2018, A5E02526190021A/RS-AD/004