Table of Contents
Advertisement
3. S
ETUP
AC Power
Each Ovation FD-205WW has a switchable power supply that can work with an input voltage of 120 VAC,
60 Hz or 230 VAC, 50 Hz. To determine the power requirements for each Ovation FD-205WW, refer to the
label affixed to the product. You can also refer to the Technical Specifications chart in this manual.
The listed current rating indicates the maximum current draw during normal operation. For more
information, download Sizing Circuit Breakers from the Chauvet website: www.chauvetprofessional.com.
.
•
Always connect the product to a protected circuit (circuit breaker or fuse). Make
sure the product has an appropriate electrical ground to avoid the risk of
electrocution or fire.
•
To eliminate unnecessary wear and improve its lifespan, during periods of non-
use completely disconnect the product from power via breaker or by unplugging
it.
AC Plug
The Ovation FD-205WW comes with a power input cord terminated with a Neutrik® powerCON® A
connector on one end and an Edison plug on the other end (U.S. market). If the power input cord that
came with your product has no plug, or if you need the change the plug, use the table below to wire the
new plug.
Connection
AC Live
AC Neutral
AC Ground
Power Linking
The product supports power linking. You can power link up to 8 products at 120 V; or 16 at 230 V.
This product comes with a power input cord. Power linking cables are available from Chauvet for
purchase.
Fuse Replacement
1.
Disconnect this product from the power outlet.
2.
Using a Phillips-head screwdriver, unscrew the fuse holder cap from the housing.
3.
Remove the blown fuse and replace with another fuse of the same type and rating
(T 3.15 A, 250 V).
4.
Screw the fuse holder cap back in place and reconnect power.
Make sure to disconnect the product's power cord before replacing a blown fuse.
Always replace the blown fuse with another of the same type and rating.
DMX Linking
You can link the Ovation FD-205WW to a DMX controller using a 3- or 5-pin DMX connection. If using
other DMX-compatible products with this product, you can control each individually with a single DMX
controller.
DMX Personalities
The Ovation FD-205WW uses a 3- or 5-pin DMX data connection for the 1-, 2- and 5-channel DMX
personalities.
•
Refer to the Introduction for a brief description of each DMX personality.
•
Refer to the Operation chapter to learn how to configure the Ovation FD-205WW to work in these
personalities.
•
The DMX Values section provides detailed information regarding the DMX personalities.
Page 8 of 22
Wire (U.S.)
Black
White
Green/Yellow
Wire (Europe)
Brown
Blue
Green/Yellow
Ovation FD-205WW User Manual Rev. 1
S
ETUP
Screw Color
Yellow or Brass
Silver
Green
Advertisement
Table of Contents
