9. ASSEMBLING THE EQUIPMENT
9.1 MOUNTING THE CUTTING DECK
1) Attach the machine lifting arms to the couplings on the equipment.
2) Insert the safety pins and the associated retaining clips.
3) Loosen the belt tensioner
4) Fit the belt.
9.2 MOUNTING THE ATTACHMENTS
When mounting the attachments, consult the specific mounting guide supplied with the specific attachment.
9.3 MOUNTING THE SEAT
1) The seat is supplied with the upper guides already mounted.
2) Connect the seat micro-switch to the electrical system connector.
3) Slide the seat into place from the front of the machine, using the guides mounted on the deck.
4) Screw the front end stop screw into place.
10. USING THE CONTROLS AND INSTRUMENTS
10.1 FORWARD - REVERSE MOTION
10.2 HAND BRAKE
10.3 BY-PASS
See figure 10.3
WARNING:
Avoid towing the machine over long distances when the by-pass is activated.
10.4 HAND THROTTLE
10.5 POWER TAKE-OFF (PTO)
1) In order to engage the PTO, push the red safety tab upwards and press the button at the same time.
2) To enable the PTO, press the button again.
10.6 RAISING THE CUTTING DECK
Pay attention to possible crushing hazards, use the lifting handles provided.
10.7 TIPPING THE BASKET
10.8 FUEL COCK
10.9 ADJUST THE CUTTING HEIGHT
10.10 TOWING HOOK
11. ELECTRICAL CIRCUIT DIAGRAM
11.0 KEY TO COLOURS
H
Grey
A
Light blue
L
Blue
B
White
M
Brown
C
Orange
N
Black
G
Yellow
See figure 9.1
See figure 9.2
See figure 9.3
See figure 10.1
See figure 10.2
See figure 10.4
See figure 10.5
See figure 10.6
See figure 10.7
See figure 10.8
See figure 10.9
See figure 10.10
R
Red
S
Pink
V
Green
Z
Purple
THIS SYMBOL INDICATES
THE EARTH
EN
31