Roland fm/am radio Owner's Manual page 30

MFX 08: REVERB
Parameter
ROOM1,
ROOM2,
STAGE1,
Type
STAGE2,
HALL1,
HALL2
Pre Delay 0.0–100 ms
Time 0–127
200–
HF Damp 8000 Hz,
BYPASS
Low Gain -15–+15dB
High Gain -15–+15dB
D100:0W–
Balance
D0:100W
Level 0–127
30
Value Description
Type of reverb
ROOM1: short reverb with high density
ROOM2: short reverb with low density
STAGE1: reverb with greater late rever-
beration
STAGE2: reverb with strong early reflec-
tions
HALL1: very clear-sounding reverb
HALL2: rich reverb
Adjusts the delay time from the direct
sound until the reverb sound is heard.
Time length of reverberation
Adjusts the frequency above which the
high frequency content of the reverb
sound will be cut, or "damped." If you do
not want to cut the high frequencies, set
this parameter to BYPASS.
Boost or cut in the low end
Boost or cut in the high end
Volume balance between the direct sound
(D) and the reverb sound (W)
Output Level
MFX 09: LINE DRIVE
Parameter Value
Strength SOFT, HARD
Type 1, 2
Drive 0–127
Low Gain -15–+15dB
High Gain -15–+15dB
Level 0–127
* This reproduces the distortion that occurs when an electrical cir-
cuit is slightly overloaded.
MFX 10: COMPRESSOR
Parameter Value
Attack 0–127
Threshold 0–127
Post Gain 0–+18dB
Low Gain -15–+15dB
High Gain -15–+15dB
Level 0–127
Description
HARD produces stronger distortion than
SOFT.
Varies the nuances of the distortion.
Degree of distortion
This also affects the volume.
Boost or cut in the low end
Boost or cut in the high end
Output Level
Description
This sets the time it takes until the level is
compressed after the input exceeds the
Threshold.
Adjusts the volume at which compression
begins
Adjusts the output gain.
Boost or cut in the low end
Boost or cut in the high end
Output Level