Specifying The Vpn Tunnel Group Name And Authentication Method - Cisco ASA 5550 Series Getting Started Manual

Chapter 7 Scenario: Remote-Access VPN Configuration
Specifying the VPN Tunnel Group Name and Authentication
Method
Step 1
78-17644-01
In Step 3 of the VPN Wizard, perform the following steps:
Specify the type of authentication that you want to use by performing one of the
following steps:
To use a static preshared key for authentication, click the Pre-Shared Key
•
radio button and enter a preshared key (for example, "Cisco"). This key is
used for IPsec negotiations between the adaptive security appliances.
To use digital certificates for authentication, click the Certificate radio
•
button, choose the Certificate Signing Algorithm from the drop-down list,
and then choose a preconfigured trustpoint name from the drop-down list.
If you want to use digital certificates for authentication but have not yet
configured a trustpoint name, you can continue with the Wizard by using one
of the other two options. You can revise the authentication configuration later
using the standard ASDM screens.
Click the Challenge/Response Authentication (CRACK) radio button to
•
use that method of authentication.
Implementing the IPsec Remote-Access VPN Scenario
Cisco ASA 5550 Getting Started Guide
7-7