Roland VS-1680 V-XPANDED Owner's Manual page 28

Press [F3 (CDRRc)]. If [F3] does not indicate "CDRRc,"
first press [PAGE] so that "CDRRc" appears, and then
press [F3 (CDRRc)].
fig.5-12
Use [ ][ ][ ][
the TIME/VALUE dial to set the parameters.
fig.5-13
Source Song
Marked songs will be loaded. Move the cursor to a song that
you wish to recover, and press [F4 (MARK)]. By pressing
[F3 (ALL)] you can mark or unmark all songs at once. By
pressing [F2 (SelSg)] you can view a list of the songs. At this
time, mark the desired song, and press [F1 (Back)].
Erase All Songs <<ATTENTION>>
If this is "On," the current drive will be initialized before the
song data is recovered. If you wish to recover while
preserving the songs that are saved on the current drive, set
this "Off."
CD Speed
Select the speed at which the song data will be recovered
from disc.
x6 (1058 KBps): Recover at 6x speed (1058 kilobytes per
second).
x2 (353 KBPs): Recover at double speed (353 kilobytes per
second).
x1 (176 KBPs): Recover at normal speed (176 kilobytes per
second). This will allow greater reliability.
] to move the cursor, and use
Using the VS-1680 with a CD-R/CD-RW drive
Depending on the disc, it may not be possible to recover reliably
from some CD-R discs at speeds of "x6 (1058 KBps)" or
"x2 (353 KBPs)." In this case, select "x1 (176 KBPs)."
Even if the "CD Speed" is set to "x2 (353 KBps)" or
"x6 (1058 KBps)" the time it takes for recovery is not always 1/2 or
1/6 of the base. This is because writing to the internal hard disk can
take a lot of time, or disc read errors can sometimes occur.
Press [F4 (Exec)]. A message will ask you for
confirmation.
fig.5-14
Press [YES]. The display will ask "STORE Current?"
(store the current song?).
If you wish to store the current song, press [YES]. If not,
press [NO]. If a demo song is selected, press [NO].
The recovery operation will begin. If the data has been
backed up to multiple discs, the disc will be ejected, and
you will be prompted to "Insert Disc #" (# is the order
number of each disk). Insert the next disc and press
[YES].
fig.5-11
When the CD-R recovery ends, you are returned to Play
condition.