Feed Dog Height - Janome HD718 Service Manual

FEED DOG HEIGHT

The highest position of the feed dog should be between 0.8 to 0.9 mm from the surface of
the needle plate when the pressure dial is set at "3" and the presser foot is raised.
1. Set the pressure dial at "3" and lower the presser foot.
2. Remove the bed cover. (See page 5)
3. Turn the handwheel toward you to set the feed dog at the highest position.
4. Loosen the setscrew (A) and nut (B).
5. Adjust the feed dog height by turning the adjusting screw (C).
6. Tighten the nut (B) and setscrew (A).
Presser foot
Feed dog
MECHANICAL ADJUSTMENT
Surface of the
needle plate
Setscrew (A)
Nut (B)
(E) (To raise)
(D)
(To lower)
Adjusting screw (C)
16