Roland JUNO-D Owner's Manual page 33

ASSIGNABLE
Specifies a function controlled by the D Beam controller.
Use VALUE [-]/[+] and select one of the following functions.
Value
MODULATION
PORTA TIME
VOLUME
BALANCE
PAN
EXPRESSION
PORTAMENTO
SOSTENUTO
SOFT
RESONANCE
RELEASE TIME
ATTACK TIME
CUTOFF
DECAY TIME
LFO RATE
LFO DEPTH
LFO DELAY
CHO SEND LEVEL
REV SEND LEVEL
MFX PARAMETER1
MFX PARAMETER2
AFTERTOUCH
BEND UP
BEND DOWN
In Patch mode, the effect will apply to the patch. In Performance mode, the effect will
apply to the patch assigned to the current part. Use [DESTINATION TONE] to
specify the tone (p. 26).
"TxCC#" refers to the controller number of control change messages sent from the
MIDI OUT connector when the D Beam controller is operated. When set to
AFTERTOUCH, Channel Aftertouch messages are sent. Set to AFTERTOUCH
mainly when you want to control an external sound generator with Aftertouch
messages.
Receiving these control change messages from the MIDI IN connector produces the
same effect as moving the D Beam controller.
* When set to MFX PARAMETER1 or MFX PARAMETER2, be sure to note the following.
• When the multi-effects Type is set to 01: STEREO EQ (p. 69) or 42: LOFI (p. 83),
Level is changed regardless of whether MFX PARAMETER1 or MFX
PARAMETER2 is selected.
• When the multi-effects Type is set to 23: 2V PCH SHIFT (p. 77), or 24: FB PCH
SHIFT (p. 78), the two parameters are changed simultaneously.
* When making the LFO RATE, LFO DEPTH or LFO DELAY settings, the effect achieved
differs depending on whether [FILTER LFO] is on or off. When [FILTER LFO] is off, the LFO
alters the pitch (vibrato effect). When [FILTER LFO] is on, the LFO changes the Filter Cutoff
frequency (wah effect).
Tx CC# Function/Parameter Changed
CC01 Vibrato Effect
CC05 Portamento Time (p. 47)
CC07 Level
CC08 The volume balance of LOWER and UP-
PER tones (p. 45)
CC10 Pan (p. 46)
CC11 Level
CC65 Portamento Switch (p. 47)
CC66 Holds the sound of the key being pressed
CC67 Softens the Tone
CC71 Tone Filter Resonance (p. 48)
CC72 Tone Envelope Release Time (p. 48)
CC73 Tone Envelope Attack Time (p. 48)
CC74 Tone Filter Cutoff (p. 47)
CC75 Tone Envelope Decay Time (p. 48)
CC76 Tone LFO Rate (p. 47)
CC77 Tone LFO Depth (p. 47)
CC78 Tone LFO Delay (p. 47)
CC93 Chorus Send Level (p. 46)
CC91 Reverb Send Level (p. 46)
CC12 The parameter specified by Multi-effect
Control 1 (p. 69)
CC13 The parameter specified by Multi-effect
Control 2 (p. 69)
----
Pitch bend effect (center → up)
----
Pitch bend effect (center → down)
----
Applying various effects to the sound
33