Honeywell CT1802 Owner's Manual page 19

Troubleshooting (continued)
Problem
No heat (continued).
Energy savings
temperature program 12
hours off.
Rooms do not warm up
at programmed time.
Temperature change
occurs at the wrong
time.
Room temperatures are
not correct.
1 Not applicable on heating-only model.
Check
— other.
— program dial for proper day or
night phase.
— clock program for heating system.
May need more time to warm up
rooms.
— program pins for correct time
locations.
— positions of thermostat setpoint
levers.
— position of subbase system
switch.
1
Contact a qualified service technician for
assistance.
Turn clock ahead 12 hours Move minute
hand clockwise
Move red pin one-half hour earlier on the
program dial.
Relocate pins to desired settings.
Reset to desired temperatures.
Move to desired operating position.
19
Action
only.
(continued)
69-0395—2