Cleaning The Micr Head - Epson TM-H6000V Technical Reference Manual

Cleaning the MICR Head

If your printer is equipped with a MICR reader, when the MICR head becomes dirty, the printer cannot read
MICR characters normally.
Approximately every year, clean the MICR head with the following or an equivalent commercially available
cleaning sheet: KIC Products "Waffletechnology
 Be sure not to use an adhesive cleaning sheet.
 Be sure that the cleaning sheet is inserted with the correct side up and in the correct direction.
 Use a cleaning sheet only one time; then discard it.
CAUTION
1
Make sure the roll paper is installed correctly and the printer is turned off.
2
Open the roll paper cover.
3
While holding down the Release button, turn the power back on.
4
Press the Release button 7 times; then close the roll paper cover.
5
After the printer prints "*** RECOGNITION MODE *** Please set check." on the roll
paper and the Slip LED flashes, insert the cleaning sheet like standard slip paper.
6
Pull the ejected paper straight up out of the printer.
7
Turn off the printer to exit the cleaning mode.
®
MICR cleaning card".
Chapter 5 Handling
5
96