Table of Contents
Advertisement
INSTALLATION DIAGRAM OF INDOOR AND OUTDOOR UNITS
Batteries
3
6
Flat head
wood screw
Wireless remote control
2
Optional Installation Parts
Part
Parts name
code
Refrigerant piping
Liquid side
: Ø6.35 mm
Gas side
: Ø9.52 mm
A
(RAS-10, 13PKVPG-E)
: Ø12.7 mm
(RAS-16PKVPG-E)
Pipe insulating material
B
(polyethylene foam, 6 mm thick)
Putty, PVC tapes
C
Refrigerant piping
must be protected from
physical damage.
Install a plastic cover or
equivalent.
Remote control holder
4
Q'ty
One
each
1
One
each
Hook
Installation
1
plate
Bush
body
Shield pipe
Vinyl tape
Apply after carrying
out a drainage test.
Saddle
Extension drain hose
(Not available,
provide by installer)
Fixing bolt arrangement of outdoor unit
• Secure the outdoor unit with fixing bolts and nuts if the unit is likely to be
exposed to a strong wind.
• Use Ø8 mm or Ø10 mm anchor bolts and nuts.
• If it is necessary to drain the defrost water, attach drain nipple 7 and cap
water proof 8 to the bottom plate of the outdoor unit before installing it.
29 mm
108 mm
Air outlet
6
For the rear left and left piping
Insert the cushion between the indoor
unit and wall, and tilt the indoor unit for
better operation.
The auxiliary piping can be connected to
the left, rear left, rear right, right, bottom
right or bottom left.
Right
Rear
right
Bottom
right
Do not allow the drain hose to get slack.
Make sure to run the drain hose sloped
downward.
The flare connection should be installed
outdoors.
Insulate the refrigerant pipes separately
with insulation, not together.
6 mm thick heat resisting
polyethylene foam
125 mm
Air inlet
Ø25 mm
600 mm
99 mm
Drain outlet
Wall
Left
Rear
left
Bottom left
Cut the piping
hole sloped
slightly.
* Drain nipple and
cap water proof are
packed in outdoor
unit.
Hide quick links:
Advertisement
Table of Contents
