500.2 Specifications - Rockford Fosgate 500.2 Operation & Installation

500. S
2
PECIFICATIONS
Dynamic Power Rating (IHF-202 Standard) - Measured at 14.4V
Per channel into a 4 load
Per channel into a 2 load
Bridged into a 4 load
Continuous Power Rating (Competition Standard) - Measured at 13.8 Battery Volts
RMS continuous power per channel, both channels driven
into a 4 load from 20 to 20,000Hz with less than
0.05% THD (Total Harmonic Distortion)
RMS continuous power per channel, both channels driven
into a 2 load from 20-20,000Hz, with less than 0.10% THD
RMS continuous power mono, into 4 load
from 20-20,000Hz, with less than 0.10% THD
Common Mode Rejection Ratio (CMRR):
Signal-to-Noise Ratio:
Frequency Response:
Bandwidth:
Damping Factor @ 4 (at output connector):
Slew Rate:
IM Distortion (IHF):
Input Impedance:
Source Unit Compatibility (+15dB gain overlap):
Input Sensitivity (+0dB gain overlap):
Pass-Thru Output:
B+ Fuse Size: (External to amplifier)
Fuse Type:
Crossover Slope:
Factory Crossover Frequency:
Factory Default Crossover Setting:
Dimensions: (including end caps)
*This is the calculated Dynamic Power Rating. Actual output power exceeded the input capability of the PowerCube.
Specifications subject to change without notice.
– 28 –
450 Watts
730 Watts
1460 Watts*
250 Watts
500 Watts
1000 Watts
Typically 40dB
>100dB (A-weighted)
20Hz-20,000Hz 0.5dB
10Hz–250kHz 3dB
>200
50V s
<0.05%
20k Ohms
34V max.
Variable from 350mV to 6V
Unity Gain
100 Amp or two 50 Amp
(1) ANL / (2) AGU
12dB or 24dB/octave Butterworth
80Hz (0.047 f)
Full Range
9-5/8"W x 18-9/32"L x 2-5/8"H
(24.4cm) x (46.43cm) x (6.6cm)