Accessories; Specifications I - Rockford Fosgate Punch P200.2 Installation And Operation Manual

ACCESSORIES
PUNCH Capacitors
Maintain the power you need to your Punch Amplifier.
PUNCH 'nstall Kits
A variety of install kits are available to help you install your Punch amplifier like a professional.
Para-Punch Remote Bass Control
This adds an adjustable center frequency control with the adjustable boost control.
See our web site for other accessories to he'p you get the most out of your system.
www.rockfordfosgate.com
Continuous Power Rating (RMS) - Measured at '4.4 Battery Volts
4 Q Load Per Channel 50 Watts x 2 60 Watts x 2
2 Q Load Per Channel 100 Watts x 2 125 Watts x 2
4 Q Load Bridged (Mono) 200 Watts x I 250 Watts x I
MODEL- PUNCH
Dimensions:
Height
Width
Length
Amplifier Fuse Rating (AmplType)
Battery Fuse Rating (Amp) External
(Not Supplied)
P200.2
2.1" (5.33cm)
II" (27.94cm)
11.7 (29.72cm)
(I) 30A/ATC
30A
P2S0.2
2.1" (5.33cm)
II" (27.94cm)
11.7 (29.72cm)
(I) 40A/ATC
40A
SPECIFICATIONS
P32S.2 P4S0.2
80 Watts x 2 100 Watts x 2
I60 Watts x 2 225 Watts x 2
325 Watts x I 450 Watts x I
2.1" (5.33cm) 2.1" (5.33cm)
II" (27.94cm) II" (27.94cm)
11.7 (29.72cm) 11.7 (29.72cm)
(I) 40A I ATC
(2) 30A/ATC
40A 60A
Signal-to-Noise Ratio
Crossover Slope
Crossover Frequency
Frequency Response
Bandwidth
Slew Rate
1M Distortion (IHF)
Signal Voltage Adjustment Range
Protection
>80dB A-weighted @ 2Vrms
12dB/octave Butterworth
variable from 40Hz to 400Hz
20Hz to 20kHz ±0.5dB
20Hz to 200kHz ±3dB
30Voits/IJS
<0.05%
Variable from 150mV to 4V (RCA Input)
NOMAD - Internal analog-computer output protection
circuitry limits power in case of overload, plus short
protection. Thermal switch shuts down the amplifier
in case of overheating.
Equalization (45Hz Punch Bass) (All models except P200.2)
Input Impedance
Variable from OdB to + 18dB
@
45Hz
10k ohms
These specifications are Amplifier Power Standard CEA-2006 Compliant
Specifications subject to change without notice
I I