Displaying Process Values T1, T2, T3, T4, Hp, Lp - Beko DRYPOINT RA eco 7200 Instructions For Installation And Operation Manual

8.15.4 Displaying process values T1, T2, T3, T4, HP, LP, %

1-
With the dryer operating (ON mode) press the
dryer's menu of functions.
2-
Press the button to display the refrigeration circuit diagram and the
dryer's instantaneous process values:
➢ T1 - Value measured by the BT1 probe in °C or °F (Dew Point
temperature)
➢ T2 - Value measured by the BT2 probe in °C or °F (Air temperature at
exchanger inlet)
➢ T3 - Value measured by the BT3 probe in °C or °F (Temperature of
refrigerant gas on compressor suction side)
➢ T4 - Value measured by the BT4 probe in °C or °F (Temperature of
refrigerant gas on compressor discharge side)
➢ HP - Value measured by the BHP probe in bar or psi (Pressure of
refrigerant gas on compressor discharge side)
➢ LP - Value measured by the BLP probe in bar or psi (Pressure of
refrigerant gas on compressor suction side)
➢ %
- Percentage value of compressor operation
➢ %
- Percentage value of fan operation
➢
- Pressure balancing solenoid valve active (powered)
➢
- Pressure balancing solenoid valve not active (not powered)
3-
Hold the button to perform the condensation drain test.
Release the button to finish the condensation drain test.
4-
Press the button to display the log file process values expressed
graphically or numerically for the last 60 minutes of dryer operation. The
default graph includes traces for all 8 process values.
5-
Use the
corresponding coloured traces.
6-
Touch the graph on the screen to position the cursor roughly near the
required time.
7-
Use the buttons to fine tune the position of the graph cursor on the
required time. Positioning accuracy is +/- 1 minute.
8-
The table on the right of the screen displays the process values stored in
the time period selected by the graph cursor in numerical format.
9-
Press the button to return to the previous screen.
NOTE! The stored process values, which are available in numerical or graph
format, relate to the last 60 minutes of dryer operation. Stored process values
that are not within this time frame are permanently deleted automatically.
DRYPOINT® RA 5400-10800 eco
, %
button to access the
buttons to display/hide the
Technical description
1-
2-
4-
3-
6-
7-
5-
9-
8-
17