System Test - Honeywell PRO TH4110B Installation Manual

PRO TH41 lOB Programmable Thermostat
Follow tile procedure below to test the heating and cooling system.
System test number System status
System switch
1 Set SYSTEMswitch to Cool.
2 Press V to turn on cooling system, then check system status (see table, below).
3 Press Y to turn off cooling system.
4 Set SYSTEMswitch to Heat.
5 Press Y to turn on heating system, then check system status (see table, below).
6 Press V to turn off heating system.
7 [Optional( Set SYSTEMswitch to Off to display thermostat information (see table, below).
Press Y to display 71-76.
8 Press and hold Y A to terminate system test at any time.
System Test
10 Heating system
30 Cooling system
70 Thermostat
information
(for reference only)
System Status
0 Heat and fan turn off.
1 Heat turns on. Fan also turns on immediately if Fan Operation
Switch is set to Electric Heat/Heat Pump (see page 6).
0 Compressor and fan turn off.
1 Compressor and fan turn on.
71 Software revision number (major revisions)
72 Software revision number (minor revisions)
73 Configuration identification code (major)
74 Configuration identification code (minor)
75 Production configuration date code (week)
76 Production configuration date code (year)
CAUTION: EQUIPMENT DAMAGE HAZARD
Compressor protection (minimum off time) is bypassed during testing. To prevent
equipment damage, avoid cycling the compressor quickly.