Customer Specified Parameters - Perkins 2206F-E13TA Operation And Maintenance Manual

SEBU9071-01
Table 3
Configuration Parameters
Engine Serial Number
Rating
Full Load Setting
Full Torque Setting
ECM Software Release Date

Customer Specified Parameters

Customer specified parameters allow the engine to
be configured to the exact needs of the application.
The electronic service tool is required in order to alter
the customer configuration parameters.
Customer parameters may be changed repeatedly as
operational requirements change.
Table 4
Specified Parameters
Top Engine Limit
Low Idle Speed
Top Engine Limit
Engine Acceleration Rate
Engine Speed Decelerating Ramp Rate
Ether Start Aid Configuration
Crankcase Pressure Sensor Installation Status
Ambient Air Temperature Sensor Installation Status
Engine Idle Shutdown Enable Status
Engine Idle Shutdown Delay Time
Engine Idle Shutdown Ambient Temperature Override Enable Status
Delayed Engine Shutdown Enable Status
Delayed Engine Shutdown Maximum Time
Aftertreatment #1 DEF Dosing Line Purge Required Air Temperature
Threshold
Delayed Engine Shutdown Aftertreatment Outlet Gas Temperature
Threshold
Engine Performance Run Out Control Configuration
Engine Governor Mode Override Switch Installation Status
System Configuration Parameters
Customer Specified Parameters
1900 rpm
600 rpm
2090 rpm
2000 rpm/s
2000rpm/s
Not Installed
Not Installed
Not Installed
Disabled
5.0 min
Disabled or Not Installed
Disabled
7.0 min
5° C (41° F)
400° C (752° F)
Not Installed
Not Installed
Operation Section
Configuration Parameters
Record
Record
(continued)
43