Royal PT-300 User Manual page 13

i. Restart the printer and AP/STA setting is successful.
2. Connect the printer to the POS (these steps depend on what
software you are using. In this example, we will describe
how to connect the PT-300 to the Royal POS software).
Device
Port
j. Go to Setup/Peripherals from the Main menu.
Speed
k. To add a new kitchen printer, choose WiFi/Network in
the "Connection type" field.
l. Write the IP address (the new one) followed by the port
number in the "Port" field. Example: 192.168.x.x:xxxx.
The port number is usually 9100 (you can verify this in
Device
the Interface information).
Port
m. Make sure the information below appears in the
following fields:
Device
n. Press the "SELF-CHECK" button and the printer will
print a test page.
NOTE: If you don't remember the printer's name, check by
pressing the FUNC button. In the interface information, the IP
ADDRESS is listed.
FIELD
FIELD
FIELD
ROYAL Thermal Printer PT-300
INFO
USB 2"/57mm Thermal Printer
Vendor Gprinter
9600 bps
INFO
USB 2"/57mm Thermal
Bluetooth Printer
(the BLUETOOTH NAME of the
printer)
INFO
Thermal LAN/WIFI Printer 80mm /
3"
11