Steam or water heating pressurized for firing oil, gas or combination gas/oil (13 pages)
Summary of Contents for Smith GSX SERIES
Page 1
S-GSXUM-3 00-GSXUM GSX GAS BOILERS USER’S INFORMATION MANUAL WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or loss of life. Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
PAGE 2 USER’S INFORMATION MANUAL 1a. Limit (Steam Boiler). An electrical device that BASIC OPERATION automatically interrupts the boiler operation when the steam pressure exceeds the “CUT IN” WARNING pressure plus the differential (1 to 5 psi). Maximum Pressure setting is 14 psig. The set Service on this boiler should be undertaken only point is usually less than 5 psig.
Page 3
USER’S INFORMATION MANUAL PAGE 3 6. Safety Relief Valve. A mechanical device that C. Lighting Instructions. Instructions to place the protects the boiler against excessive pressure. boiler in operation and to turn off the boiler are The safety relief valve can discharge a large shown on the Lighting Instructions Label posted on amount of steam or hot water –...
Page 4
PAGE 4 USER’S INFORMATION MANUAL Figure 3: Operating Instructions, Spark Ignition Natural Gas & LP Gas...
Page 5
USER’S INFORMATION MANUAL PAGE 5 Figure 4: Operating Instructions, Spark Ignition Natural Gas & LP Gas...
PAGE 6 USER’S INFORMATION MANUAL USER MAINTENANCE WARNING WARNING Service on this boiler should be undertaken only Product Safety Information by trained and skilled personnel from a qualified Refractory Ceramic Fiber Product service agency. Inspections should be performed at intervals specified in the Installation, This appliance contains materials made from Operation and Maintenance Manual and this refractory ceramic fibers (RCF).
Page 7
USER’S INFORMATION MANUAL PAGE 7 C. Inspect Pilot and Main Burner Flames (Monthly). 6. Adjust thermostats to normal setting. 1. Remove front jacket panel by lifting and pulling 7. Install front jacket panel. out. D. Controls (as required by control manufacturer)¹. 2.