Samsung SCX-5935FN Service Manual page 113

Message
Shake toner cartridge.
System error: #02-000.
Please turn off then on
System error: #02-003.
Please turn off then on
System error: #10-004.
Please turn off then on
This IP address
conflicts with an IP
address already in use.
Check it
Toner cartridge is not
compatible. Check
user's guide
Toner cartridge is not
installed. Install it.
Toner cartridge is worn.
Replace with new one
Toner is empty. Replace
toner cartridge
Toner is low. Order new
toner cartridge
Too much paper in
output bin tray. Remove
printed paper
Service Manual
Alignment & Troubleshooting
Description
The toner supply is low.
1. At warm up, the temperature is less
than reference temperature for 20
sec.
2. Abnormal ADC has occurred.
3. ZeroCross Signal detect error has
occurred.
The communication error of the
MEGA88 Micom
UI error
The IP address is used in other place
elsewhere.
The toner cartridge you have installed
is not for your machine.
The toner cartridge is not installed
or the CRUM in the cartridege is not
properly connected.
The color toner cartridge has run out.
The machine stops printing.
The lifespan of the color toner
cartridge which the arrow indicates is
reached.
Toner Cartridge is almost empty.
The printed papers are full on the
output tray.
Thoroughly roll the new cartridge five
or six times to distribute the toner
evenly inside the cartridge.
1. In case of meaning 1, replace the
Fuser unit.
2. In case of meaning 3, replace the
Engine contol board or Fuser control
board or SMPS.
1. Open the side cover and close it.
2. Check the envelope pressing
device.
1. check the UI connector.
2. If the problem persists, replace the
OPE board.
3. If ther problem persists, replace the
maina board.
Check the IP address or obtain a new
IP address.
Replace the toner cartridge.
Check the connection between the
CRUM connector of the toner cartridge
and Set.
Replace the toner cartridge.
Replace the toner cartridge.
Replace the toner cartridge.
1. Remove the paper on outbin tray.
2. Check the Outbin Full Senosr
(Component Test -> Sensor Read ->
OB value)
4-62
Suggested solutions
Samsung Electronics