Filling The Tub; Setting Controller To Mute - Rinnai REU-VA3237FFU Operation And Installation Manual

Using the Water Smart / Bath Fill Function

Filling the Tub

1. Press the "Water Smart / Bath Fill"
button once. The button will
illuminate, a tone will sound, and
the word "Bath" will appear next to
the temperature setting.
2. The voice prompt will announce
ON!
"The hot water system is ready.
COLD
Open the hot water tap."
Open the hot water tap. The "In
Use" indicator will illuminate on all
HOT
controllers. The hot water will
begin to flow.
3. When the preset volume of water
ON!
has been produced then
COLD
•
•
HOT
•
•
4. Turn off the bath hot water tap and
push the Bath Fill button. The
water heater will not allow hot
water to flow from any source until
the "Water Smart / Bath Fill" button
is pushed.
The button light will go out and the
word "Bath" will disappear from the
display.

Setting Controller to Mute

Models MC-91 and MCC-91
To eliminate the beeps when keys are pressed or to turn the beeps back on, press and hold both the
buttons until a beep is heard (approximately 5 seconds).
the water flow will cease
the "Water Smart / Bath Fill"
button will flash
a tone will sound
the voice prompt will
announce, "Bath fill is
complete. Turn off the bath
hot water tap and push the
Bath Fill button."
VA Series Indoor LS Manual
To stop the water flow during the Bath
NOTICE
Fill function, press the "Water Smart /
Bath Fill" button. The button will flash
To Stop the
and the voice prompt will announce,
Bath Fill "Hot water is not available. Turn off
all hot water taps and push the Bath
Before it
Fill button." Follow the voice prompt
Finishes
instructions.
During the bath fill function, any hot
NOTICE
water flowed at other locations,
subtracts from the total amount of
water for the bath. For example if the
When
bath fill function is set for 50 gallons
Other Taps
and 5 gallons of hot water are used at
Are Open
other locations during the fill period
then the bath will only fill with 45
gallons.
and
11