Weber 3600 Installation Manual page 16

Reinstall Burner Tubes
You will need: A 3/8" nut driver.
A) While holding the inside burner tube with the
mounting bracket rotated up 90° (8), carefully slide
the burner tube back into the hole on the right side
of cookbox (9). Looking through the view port on the
front panel of the cabinet (10), align the locking tab of
the burner tube opening with valve orifice (11). Rotate
the burner tube 90° to the flat position to lock it to the
valve orifice (12).
B) Check that igniter electrode is properly seated under
burner tube and reinstall screw that secures the
inside burner tube to the cookbox (13).
C) Holding the outside burner tube with the mounting
bracket rotated up 90°, carefully slide the burner tube
back into the hole on the right side of cookbox (14).
Looking through the view port on the front panel of
the cabinet (10), align the locking tab of the burner
tube opening with valve orifice (11). Rotate the burner
tube 90° to the flat position to lock it to the valve
orifice (12).
D) Reinstall screw that secures the outside burner tube
to the cookbox (15).
m CAUTION: The burner tube openings (16)
must be positioned properly over the
valve orifices (17).
m WARNING: You should check for
gas leaks every time you disconnect
and reconnect a gas fitting. Refer to
"CHECKING FOR GAS LEAKS."
16
WWW.WEBER.COM
®
PREPARING TO INSTALL
9
10
11
12
8
14
15
16
17
13