RIDGID AC9940 Operator's Manual page 10

ASSEMBLY
EXTENSION BAR(S) OPERATION
See Figures 10 and 11.
Both extension bars may be adjusted to provide maximum
workpiece support. To adjust the extension bars:
Loosen adjustable
n
clockwise.
NOTE: Adjustable handle can be repositioned if
necessary. Lift up on handle and rotate to desired
position then release handle.
Slide out extension bar to desired position and tighten
n
extension bar handle.
LOCKING PIN
KNOB
handle by turning
ADJUSTABLE
HANDLE
NOTE: There is a catch to limit the overall extension bar
travel.
Pull out on locking pin knob and swing leg down until
n
locking pin locks leg in the down position.
Turn foot knob counterclockwise to loosen and slide
counter
n
foot extension down until foot contacts the floor. Tighten
foot knob.
Repeat for the other extension bar.
n
NOTE: It may be necessary to realign roller assemblies
with the miter saw table. See Mounting and Aligning Roller
Assembly on page 9.
Fig. 10
10
LEG
Fig. 11