10.2. Self Check - Haier HW60-1081 Service Manual

Service Manual
Model No:HW60-1281S/1081

10.2. Self check

1.How to start
Press the strong wash button and power on at the same time, activate self-inspection
program the LED will display
will be displayed; Press "start/pause" button agin, self-inspection program will start.
2. Test item
1) When the door switch is closed for 3 seconds, 88:88 will be displayed.
2) When the main wash valve allows water to let in for 5 seconds, 77:77 will be displayed.
3) When the prewash valve allows water to let in for 5 seconds, 77:77 will be displayed.
4) When the softy water valve allows water to let in for 5 seconds, 77:77 will be displayed.
5) When the main wash valve, the prewash valve and also the softy water valve allow
water to let in for 5 seconds at the same time, 77:77 will be displayed.
6) Heater runs for 10 seconds, 66:66 will be displayed.
7) The drain pump runs for about 1 mins, 55:55 will be displayed
8) Continue to drain,distribute for
800rps
44:44 will be displayed.
8) Self-inspection end: END will be indicated on display.
Model selection
1.Press the rinse button and power on at the same time for 4 seconds, and it will enter the
model-selection mode.The default display shows 1260.
2. The shows display 1460,the speed button can adjust among1460/146A /1260/126A
/1250/125A /1060/106A /1050/105A.It is avaiable to power off when press the storage
temperature button.
3.The type only can adjust from the high speed to low speed, and can not reverse adjust
(for example: 1200 model can adjust to 1000 types, but not from 1000 to 1200 types).
4.When the temperature sensor NTC disconnected, can adjust in reverse direction.
5.Model HW60-1281S/1081 you should choose 1260/1060.
10 seconds at speed 90rps and spin for 30S at speed
18
Issue
Rev.
button,machine model