HP Touchsmart TM2 User Manual page 74

9. If you are replacing a memory module, remove the existing memory module:
a.
b.
10. Insert a new memory module:
CAUTION:
only. Do not touch the components on the memory module, and do not bend the memory module.
a.
b.
64 Chapter 11 Memory modules
Antenna House XSL Formatter (Evaluation) http://www.antennahouse.com/
Pull away the retention clips (1) on each side of the memory module.
The memory module tilts up.
Grasp the edge of the memory module (2), and gently pull the module out of the memory
module slot.
CAUTION: To prevent damage to the memory module, hold the memory module by the
edges only. Do not touch the components on the memory module.
To protect a memory module after removal, place it in an electrostatic-safe container.
To prevent damage to the memory module, hold the memory module by the edges
Align the notched edge (1) of the memory module with the tab in the memory module slot.
With the memory module at a 45-degree angle from the surface of the memory module
compartment, press the module (2) into the memory module slot until it is seated.