Installing Panel - Lennox Elite XP13-024 Installation Instructions Manual

INSTALLING PANEL
Install the Iouvered panels as follows:
1. Position the panel almost parallel with the unit as
illustrated in figure 13, detail D with the screw side as
close to the unit as possible.
2. With a continuous motion slightly rotate and guide the
lip of top tab inward as illustrated in figure 12, details
A and C, then upward into the top slot of the hinge
corner post.
3. Rotate panel to vertical to fully engage all tabs,
4. Holding the panel's hinged side firmly in place, close
the right-hand side of the panel, aligning the screw
holes.
5. When panel is correctly positioned and aligned, insert
the screws and tighten.
PANEL SHOWN SLIGHTLY ROTATED TO ALLOW TOP TAB TO EXIT (OR ENTER)
TOP SLOT FOR REMOVING (OR INSTALLING) PANEL.
LIP
\
DETAIL
SCREW
ROTATE IN THIS DIRECTION;
THEN DOWN TO REMOVE
PANEL
J
il C
J
IMPORTANT! DO NOT ALLOW PANELS
TO HANG ON UNIT BY TOP TAB. TAB IS
FOR ALIGNMENT AND NOT DESIGNED
TO SUPPORT WEIGHT OF PANEL.
Figure 12. Removing/Installing Louvered Panels
(Details A, B and C)
HOLD DOOR FIRMLY TO THE HINGED
ANGLE MAY BE TOO SIDE TO MAINTAIN
EXTREME -- _ FULLY-ENGAGED TABS
PREFERRED ANGLE
WITH THE UNIT AS POSSIBLE)
WHILE INSTALLING PANEL.
Figure 13. Removing/Installing Louvered Panels
(Detail D)
STABILIZING UNIT ON UNEVEN SURFACES
To help stabilize an outdoor unit, some installations may
require strapping the unit to the pad using brackets and
anchors commonly available in the marketplace,
With unit positioned at installation site, remove two side
Iouvered panels to expose the unit base pan. Install the
brackets as illustrated in figure 14 using conventional
_ractices; replace the panels after installation is complete.
Slab Side Mounting
Deck Top
Mounting
STABILIZING BRACKET MINIMUM 1
{18 GAUGE METAL- 2" PER SIDE _
WIDTH; HEIGHT AS
REOD,;BENDTOFORM
liI°
FOR EXTRA
STABILITY
ONE BRACKET PER SIDE (MIN.); FOR EXTRA STABILITY,
2 BRACKETS PER SIDE, 2" FROM EACH CORNER.
Figure 14. Installing Stabilizer Brackets
Page 8
505327M 04/08