Operation - Ryobi ES5000 Operator's Manual

TURNING THE INSPECTION SCOPE ON/OFF
 To turn the unit ON, press and hold the power button
until the button starts to light up green (~5 seconds).
 The button should begin flashing within a few seconds.
When it stops flashing and turns SOLID GREEN, the
scope is ready to connect.
 To turn the unit OFF, press and hold the power button
for ~5 seconds until the button starts a FLASHING RED
pattern. It will turn OFF in a few seconds.
ATTACHING THE SMARTPHONE TO THE
INSPECTION SCOPE
 Insert the smartphone into the clip and make sure it is
securely attached before use.
CONNECTING THE INSPECTION SCOPE
YOUR WIRELESS DEVICE
 Turn the unit ON.
 On your phone, turn the WiFi network ON and open to
the WiFi connection screen.
 Select the network named "PhoneWorksScope..." with
some trailing letters and numbers. Enter the default
password 12345678 or the password you have set as
described in Setting a new wireless password.
 Once the phone indicates that it is connected to the new
network, go the Ryobi
phone.
 Select and Open the Ryobi
 Open the Inspection Scope sub-app. The video feed
should start within a few seconds.
NOTE: Your phone may not have internet access while it is
connected to the inspection scope.
SETTING A NEW WIRELESS PASSWORD
Setting an individual password is done through the app. A
valid password must be from 8 to 63 characters.
Tu r n t h e u n i t O N a n d c o n n e c t t o t h e

PhoneWorksScope... WiFi network.
 Open the Ryobi Phone Works
TM
Scope sub-app.
Click the "Set New Password" icon or "Reset Password"

button (See Figure X).
Enter the new password and click OK.


OPERATION

Phone Works App on your
TM TM
Phone Works App.
TM TM
and the Inspection
App
TM
WITH
6 — English