Datalog Operations; Auto Log (Timer); Manual Logging - GE Druck DPI 610 User Manual

Memory Operations
Data Log Operations
Data Log is a special application of store mode that enables the calibrator to either
automatically log displays at preset time intervals or to manually log a display on
operation of the STORE key. Logged data is written to a user specified file.
To set-up a Data Log file, proceed as follows:
• Select a task, other than BASIC. If using ADVANCED, set-up required output
parameters.
• Use SETUP to select Data Log from the Store Mode Menu (see page 37).

Auto Log (Timer)

Press STORE and set up the Data Log file parameters as shown below. Use CHANGE
VALUE (F1) followed by cursor keys to set field values. For Auto Log, set TRIGGER field to
PERIODIC.
DATA LOGGING
FILENAME :
DATE :
TIME :
STORE
TRIGGER:
PERIOD :
POINTS :
CHANGE
VALUE

Manual Logging

Enter the file details as shown above and select KEYPRESS for TRIGGER field. Screen
reverts to displayed parameters showing set-up file as shown below:
DATA LOGGING
FILENAME :
DATE :
TIME :
TRIGGER :
PERIOD :
POINTS :
CHANGE
VALUE
Use a combination of STORE and LOG NOW (F1) to log events as follows:
STORE
ENTER VALUE
21/02/99
12:29
PERIODIC
00:05
10
START
LOGGING
DATA LOGGING
LOGFILE3 FILENAME :
21/02/99 DATE :
12:29 TIME :
KEYPRESS TRIGGER :
PERIOD :
POINTS :
START CHANGE
LOGGING VALUE
24 V OFF
TASK: ADVANCED
LOG FILE : LOGFILE3
V
VOLTAGE
bar
PRESSURE INT
LOG STOP
NOW LOGGING
DATA LOGGING
FILENAME : LOGFILE2
DATE : 21/02/99
TIME : 12:29
TRIGGER : PERIODIC
PERIOD : 00:05
POINTS : 10
CHANGE START
VALUE LOGGING
TASK: ADVANCED
LOG FILE : LOGFILE3
LOGFILE3
21/02/99
12:29
VOLTAGE
KEYPRESS
PRESSURE INT
START
LOGGING
TASK: ADVANCED 24 V OFF
LOG FILE : LOGFILE3
VOLTAGE
PRESSURE INT
31
Data Log
24 V OFF
TASK : CO2INLET
POINT 10 OF 10
V
VOLTAGE
bar
PRESSURE INT
24 V OFF
V
bar
ENTER VALUE
V
bar
K415 Issue No. 1
CLEAR
(ANY KEY)