Group Diagnostics Parameter; Synchronization Group Parameter - Siemens Simantic ET 200S Manual

Time value
Teach-in disable
Note
Unused channels of the module must be deactivated otherwise the wire break diagnosis will
be reported.
Measurement type parameter: De-activated
• All the diagnostics are suppressed.
• Sensitivity/distance values and circuit states are set to "0".
• The sensor is switched off.
5.2.2

Group diagnostics parameter

If group diagnostics is enabled, a pending diagnostics message is entered.
Reference
Information on channel-related diagnostics can be found in the
Instructions
5.2.3

Synchronization group parameter

• Sensors between different modules of the 4 IQ-SENSE may influence one another (e.g.
• To prevent interference from neighboring sensors on different modules, this parameter
• Sensors on the same module cannot interfere with one another.
ET 200S
Manual, Edition 10/2005, A5E00514527-01
Parameters
•
•
•
•
•
•
•
•
•
•
•
•
•
.
scattered light).
can be used to allocate a separate synchronization group to every module. Modules in
different synchronization groups do not interfere with one another.
Range of values
5 ms
10 ms
20 ms
50 ms
100 ms
200 ms
500 ms
1 s
2 s
5 s
10 s
Teach-in
with button
possible
Teach-in
with button not
possible
4 IQ-SENSE (6ES7138-4GA00-0AB0)
Default setting
5 ms Channel
Teach-in
with button Channel
possible
ET 200S Operating
Applicability
5-3